How To Configure The Korbyt PWA Player On A Crestron Device including AirMedia

This process will be using Crestron’s Web Configuration Interface.

To access the web configuration interface using the touch screen IP address and configure it for Korbyt:

• Ensure that the Crestron panel is connected to the network.

• You will need the IP address for the Crestron Device

  • If Available - Use the Device Discovery tool in Crestron Toolbox™ software to discover the device and its IP address on the network.

• Enter the device IP address into a web browser that is on the same network

  • This will open the controls for the Crestron

  • Crestron Support Article - Connect to the Receiver

• Navigate to Settings > Applications.

  • Creston Support Article- Settings

• Select Korbyt from the Application Mode drop-down menu.

  • Note: If device is not on 2.1.58 firmware or later, then select ‘EMS’ as the application type and enter the Korbyt PWA address that is required for connecting to the hosted Korbyt Tenant. (PWA Address: https://www.korbyt.com/pwa)

• Click Save Changes on the top right of the screen.

• When prompted, reboot the touch screen. The touch screen reboots into the selected scheduling mode.

• Upon reboot, you should be prompted with the Korbyt Provisioning page with the 12 character provision code.

• Provision the player following the standard Korbyt Player Provisioning process: Adding Players to your Korbyt Tenant - Provisioning